Steering Wheel Buttons Not Working

The Steering Wheel controls will not work.

Please follow the video at www.youtube.com/digoptions. If still no luck contact us through our contact page.

Note. If some buttons have the same function you will need to change the impedance from high or low otherwise you may need to add a 100Ohm resistor to one of the steering wheel wires and a 200Ohm resistor to the other.

 

Important if plugs don't match or match but still not working.

If the steering wheel controls do not work after install and the plug does not match you can find your vehicle's steering wires easily with a multimeter. First you need to find a ground wire. Connect the GND wire from our steering plug to this. Second run a multimeter over the left over wires. When you find a power value changing when you push a button on the steering wheel you have found the steering wire. Connect this one to the AD1 wire of the DIG Options system.


If you have a DIG Options Platinum System please do as follows:

  1. Push Setting (top left)
  2. Push General
  3. Push down and select Steer Wheel
  4. Push reset
  5. Push volume + on screen
  6. Push start
  7. On your steering wheel push volume +
  8. Now store

 

Repeat for all buttons.

 

If some buttons have the same function then push reset and select Low (or High) Impedence.

If you don't get any readings it's likely your installer may have not connected the steering wires.

 


If you have a DIG Options Roadmaster System please do as follows:

  1. From the Menu, swipe right twice
  2. Push SWC
  3. Push the function you wish to assign
  4. Push Start
  5. Push the corresponding button on your steering wheel
  6. Push Store
  7. The code number for the button should change in the top right
  8. Repeat process for all Buttons
  9. Save and exit

 

If some buttons have the same function then push reset and select Low (or High) Impedence.

If you don't get any readings it's likely your installer may have not connected the steering wires.

 


Leave a comment

Comments have to be approved before showing up